Maytag 40136001 installation instructions Canada TTY USA Only, Position 5AND Level Washer, Connect

POSITION

5AND LEVEL WASHER

Position washer in final location on clean, dry, firm, and level floor.

NOTE: To avoid damage to legs and base, do not slide washer across floor if leveling legs have been extended.

Loosen 7/8" locknuts and extend front leveling legs. Place rubber foot pads on all four leveling legs. Adjust front 2 leveling legs until machine is level side-to-side. Be sure machine does not rock. Tighten locknuts up to washer base, or washer will move out of position during operation.

Once front legs are adjusted, gently tilt washer forward on front legs and lower into place to correctly set rear self-leveling legs.

Check that washer is level front-to- back and side-to-side. WASHER

MUST NOT ROCK.

1. Level Front Legs

	Lock
	nut
	Rubber
Leveling	foot pad
foot

2. Level rear legs

CONNECT

6POWER CORD TO ELECTRICITY

See Installation Requirements section. Plug washer into 3-prong grounded outlet only.

CLEAN TUB AND

7RUN THROUGH ONE WASH CYCLE

WITHOUT CLOTHES

Wipe tub with clean rag and soap diluted in warm water to remove any oil used in manufacturing. Use household spray cleaner if necessary.

Add water and detergent to washtub, and run before first use.

Questions?

See the User’s

Guide or call

Maytag Appliances

Sales Company

1-800-688-9900

USA

1-800-688-2002

Canada

1-800-688-2080 TTY USA Only

3