INSTALLATION INSTRUCTIONS
WARNING
Excessive Weight Hazard
Use two or more people to move and install washer. Failure to do so can result in back or other injury.
Remove Shipping Strap
1.Remove tape that covers shipping strap. Pull to completely remove the shipping strap with 2 cotter pins from the inside of the washer.
Connect the Hoses
Proper connection of the drain hose avoids damage to your floor due to water leakage. Read and follow these instructions.
Connect the inlet hoses to the washer
1.The washer must be connected to the water faucets using the new inlet hoses. Do not use old hoses. Insert new flat washers (supplied) into each end of the inlet hoses. Firmly seat the washers in the couplings.
A
B
A. Shipping tape
B. Shipping strap
2.Pull firmly to remove the end of shipping strap from the back of the washer. The shipping strap plug must be completely removed from the washer for the
Save the shipping strap for later use.
AB
A.Coupling
B.Washer
2.Attach hose to bottom inlet valve opening first.
A
B
A.Cold water inlet valve
B.Hot water inlet valve
3.Attach second hose to top inlet. Tighten couplings by hand; then use pliers to make an additional
NOTE: Inlet valve threads are plastic. Do not strip or cross- thread.
Connect the drain hose
NOTE: Slide washer onto cardboard or hardboard before moving across floor.
1.Move washer close to final position.
2.Put “hook” end of drain hose into laundry tub or standpipe.
3.Estimate the length of drain hose needed when washer is in final position. Hose must be cut exactly to length so “hook” end is held tightly over edge of standpipe.
6
