Maytag 120 V, 60 HZ Operating Tips, Typical full load sizes, Moving the Washer to a New Location

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

Checklist for washer operation:

Check the following if the washer is not operating properly:

1.Power supply cord is plugged in.

2.Circuit breaker is not tripped or fuse is not blown.

3.Timer has been advanced to start of a cycle.

4.Water faucets are turned on.

5.Inlet and drain hoses are not kinked.

6.Washer lid is closed.

7.Inlet valve is not frozen if not protected from the weather.

8.Suds level. Excess suds will slow the spin and cause poor rinsing. Operate the washer through a complete cycle with no detergent. Use less detergent or a controlled suds type detergent in future loads.

If you need assistance:tance:

ContactThe MaytagyourConsumerauthorizedInteractionMaytag® Commercialenter will answerLaundryany

distributorquestions .aboutlocatpTo eratingauthorizedmaintaininMaytagyouryour® wCommercialsher not covereLaundry indistributor,the Installationor for Instructionsweb inquiries,. ThevisitMaytag Consumer

wwwInteractioMaytagCommercialLaundry. Center is open 24 hours.coma day,. 7 days a week. Just Ifdialyou1-cannot800 NOlocateBELTSyour(1-800distributor,-662-3587)the-Commercialthe call is freeLaundry.

SupportWhen youCentercall, youwillwillanswerneedanythequestionswasher modelaboutnumberoperatingand serial ornumaintainingber. Both numbersyour washercan benotfoundcoveredon thein theserialInstallation-rating plate Instructilocated onsyour. washer.

Just dial 1-800 NO BELTS (1-800-662-3587)—the call is free.

When you call, you will need the washer model number and serial number. Both numbers can be found on the serial-rating plate located on your appliance.

Operating Tips

WARNING

Fire

Never place items in the washer that are dampened with

No washer can

Do not dry anything that has ever had any type of oil on it

Doing so can result

It is recommended that fiberglass items not be washed in coin- operated washers. If these items are washed in the washer, run the washer through a complete cycle to rinse any residue away that might be left in the washer.

Typical full load sizes

Load Type	Loading	Load Type	Loading
	Suggestion		Suggestion
Mixed Load	3 double sheets	Heavy Work	3 pair pants
	4 pillowcases	Clothes	3 shirts
	6 pair shorts		1 coverall
	8 T-shirts		4 pair jeans
	2 shirts		1 overall
	2 blouses
	8 handkerchiefs
Permanent	2 double or	Knits	3 blouses
Press	1 king size sheet		4 slacks
	1 tablecloth		6 shirts
	1 dress		4 tops
	1 blouse		4 dresses
	2 slacks
	3 shirts
	2 pillowcases

Moving the Washer to a New Location

Remove the front legs from the base of the washer.

Place both rear leveling legs in the upper position and tape securely.

Apply tape to the side and bottom of the cabinet near the rear.

Open washer lid, wedge a blanket between the tub ring and the cabinet top restricting the tub movement.

	Front legs
Rear	Tape 2 sides
legs

Handle washer gently. Do not drop washer while using hand

truck.

9