Maytag CER3725AGW Maintenance, Oven Door, Oven Light, Leveling Legs, Oven Window select models

Maintenance

Oven Door

CAUTION

•Do not place excessive weight on or stand on an open oven door. This could cause the range to tip over, break the door, or injure the user.

•Do not attempt to open or close door or operate oven until door is properly replaced.

•Never place fingers between hinge and front oven frame. Hinge arms are spring mounted. If accidentally hit, the hinge will slam shut against oven frame and could injure your fingers.

To remove:

1. When cool, open the oven door to the first stop position (opened about four inches).

2. Grasp door at each side. Do not use the door handle to lift door.

3. Lift up evenly until door clears hinge arms.

To replace:

1.Grasp door at each side.

2.Align slots in the door with the hinge arms on the range.

3.Slide the door down onto the hinge arms until the door is completely seated on the hinges. Push down on the top corners of the door to completely seat door on hinges. Door should not appear crooked.

Important: The oven door on a new range may feel “spongy” when it is closed. This is normal and will decrease with use.

Oven Window (select models)

To protect the oven door window:

1.Do not use abrasive cleaning agents such as steel wool scouring pads or powdered cleansers as they may scratch the glass.

2.Do not hit the glass with pots, pans, furniture, toys, or other objects.

3.Do not close the oven door until the oven racks are in place.

Scratching, hitting, jarring or stressing the glass may weaken its structure causing an increased risk of breakage at a later date.

Oven Light

CAUTION

•Disconnect power to range before replacing light bulb.

•Use a dry potholder to prevent possible harm to hands when replacing bulb.

•Be sure bulb is cool before touching bulb.

•Do not touch hot bulb with a damp cloth as this may cause the bulb to break.

To Replace Oven Light Bulb:

1. When oven is cool, hold bulb cover	BULB COVER
in place, then slide wire retainer
off cover.
Important: Bulb cover will fall if
not held in place while removing
wire retainer.	WIRE
	RETAINER

2.Remove bulb cover and light bulb.

3.Replace with a 40-watt appliance bulb.

4.Replace bulb cover and secure with wire retainer.

5.Reconnect power to range. Reset clock.

Leveling Legs

CAUTION

Be sure the anti-tip bracket secures one of the rear leveling legs to the floor. This bracket prevents the range from accidentally tipping.

Be sure the range is leveled when installed. If the range is not level, turn the leveling legs, located at each corner of the range, until range is level.

ANTI-TIP BRACKET

LEVELING LEG

6