Instructions for Installation (cont'd)
16. Find the loop of thermostat wiring cable (grey colored) inside the junction box and pull it out.
19.Strip the thermostat cable outer insulation back I_A inches. Strip the ends % inch on each of the six colored wires.
LOOP | _ | m | ud |
17. Cut the thermostat wiring cable in half at the top of the loop.
__ O _ | ._ | 1.250J " |
20.A second terminal connector is provided in a small bag con-
tained within the large plastic manual envelope attached to the side of the water heater. Loosen each screw in the termi-
nal connector. Insert the six colored wires of the thermostat cable into the terminal connector and tighten each screw to secure each wire. Be sure to arrange wires in exact color sequence as showm
18.The wire side of the loop which does not have the red tape strip on it should be cut off or pressed into the junction box
out of the way.
| R_RTIApPE |
I | TH_AT |
ACTIc_ | ALF |
6-WIRCAE "LE
Lu |
| _ | = |
|
z |
| _ = |
| |
|
|
|
| TERMINAL |
6 | A | 2 | 1 _TCONNECTOR |
|
TERMtNAL | ( _ | THERMOSTAT | ||
CONNECTOR | _E |
|
ACAUTION
The six colored insulated wires must be installed in the terminal connector exactly as shown for the
thermostat to operate correctly.
water heater in Step 8.
21. Locate the end of the remote thermostat cable routed to the
19