Maytag HE21250PC Instructions for Installation contd, Installation Checklist, Cold, Dischargepipe

Instructions for Installation (cont'd)

Installation Checklist

1.Whether or not the element conversion is made, the

model rating plate must be marked. Using a hard point

ink pen, check the appropriate block within the model rat- ing plate, which is located adjacent to the lower access panel.

2.Is the fuse or circuit breaker size correct as shown in the chart m the Product Specifications section.

3.Are the wires from the circuit breaker or fuse service to the water heater's junction box on the correct wire size (gauge) as shown in the chart in the "Product Specifications" sec- tion?

H_OT __...._ _ _ COLD

CONDUIT - I

TEMPERATURE-

/ PRESSURE

/ RELIEFVALVE

4.	Is the new temperature-pressure			relief valve properly	--DISCHARGEPIPE
	installed, and piped to an adequate drain? See				(Do not capor
					plug)
	"Temperature-Pressure Refief Valve" in the "Instructions
	for Installation"	section.
5.	Is the water heater completely			filled with water? See
	"Filling the Water Heater" instructions in the
	Instructmns for Installatton sectton.
6.	Will a water leak damage anything? See "Locating the				I 6"AIR GAP
	New Water Heater" in the "Instructions for Installation"
	section.				FLOORDRAIN
7.	Are the cold and hot water lines connected to the water
	heater correctly? See "Water Piping" instructions in the
	Instructzons for InstaUatmn		section.
8.	Is there adequate	clearance	for	maintenance around the
	water beater?

9. If the programmable thermostat has been moved to a

remote location, has the wiring been done correctly?
10. Do you need to call your electric company to check your		'_ _*	,,_,'_,_
wiring?	_	" _	w_
			I_I_IqUCTION

® Mayteg isa Trac_ner k ol Mayt_l Cotporabon is used Und¢_-Lk_*.iso*o 8tale InduslT_esIn, o

MODEL RATING PLATE

22