Maytag LAT9804 Before You Call For Service, Check these points if your washer, Page, U. S

BEFORE YOU CALL FOR SERVICE

Check these points if your washer.,,

Plug cord into live electrical outlet. _ Clieck fuse or reset circuit breaker.

equipped with buttons, be sure they are fully depressed.

iTurn the control knob to proper cycle and pull knob out to start the washer. If Tnrn both faucets on fully.

•Straighten inlet hoses.

•Hose filter screens plugged. Disconnect hoses and clean screens.

Cheek fuse or reset circuit breaker.

*Tuna the control knob to proper cycle and _ull knob out to start the washer. If equipped with buttons, be sure they are fully depressed.

•Close lid and pull knob out to start the washer. For your safety, washer will not agitate or spin unless the lid is closed.

•The washer is equipped with a lid switch failure detector. If the lid switch should malfunction, the detector will stop operations for your safety. Call for service.

•Off-balance load. Redistribute the load evenly, close the lid and pull knob out. Check for leveling. Be sure water level is acceptable for load size.

•Check fuse or reset circuit breaker.

•Straighten hoses. Eliminate kinked hoses. If there is a drain restriction, call for service.

•Close lid and pull knob out to start the washer. For your safety, washer will not agitate or spin unless the lid is closed.

•Suds lock - caused by too much suds. Rewash without detergent. Use correct amount of a low-sudsing detergent.

•The washer is equipped with a lid switch failure detector. If the lid switch should malfunction, the detector will stop operations for your safety. Call for service.

Off-balance load. Redistribute the load evenly, close the lid and pull knob ont. Check for leveling. Be sure water level is acceptable for load size.

•Plug cord into live electrical outlet.

•Check fuse or reset circuit breaker.

Turn the	control knob	to proper cycle and pull knob		out to start the washer. If
	with	be	depressed.
i equipped	buttons,		sure they are fully	your safety, washer will not
Close lid and pull knob out			to start the washer. For
agitate	or spin unless	lid	is closed.

•This may be a pause or soak period in the cycle. Wait briefly and it may start.

•The washer is equipped with a lid switch failure detector. If the lid switch should malfunction, the detector will stop operations for your safety. Call for service.

•Make sure hose connections are tight.

•Make sure end of drain hose is correctly inserted and secured to drain facility.

•Extended soaking - soak for 30 minutes or less.

•Make sure washer is level and firm to the floor.

_'	•	Weak floors can cause vibration					and walking.
	•	Turn	both	faucets	on fully.
	•	If equipped		with	a temperature		selector	knob, be	sure it is set directly	on a temper-
		ature setting and not between settings.
	•	Make	sure	temperature		selection	is correct.		and inlet connections.
	• Make		sure	hoses	are connected		to correct	faucets		Be sure
		water supply is regulated correctly. Flush water line before filling washer.
	•	Check the		water	heater.	It should be set to deliver a minimum 120°F				(49°C)

hot water at the tap. Also check water heater capacity and recovery rate.

• Hose filter screens plugged. Disconnect hose and clean screens

NOTE: For further information	contact Maytag Customer Assistance:	U.S.	1-800-688-9900
		Canada 1-800-688-2002

PAGE 9