TORING THE CLOTHES WASHER
Washers can be damaged if water is not removed from hoses and internal components before storage. Prepare the washer for storage as follows:
o Select the Quick Wash cycle and add bleach to the
automatic dispensen Run the washer through the cycle without a loa&
o Turn the water faucets off and disconnect the inlet hoses.
Disconnect the clothes washer from the electrical sup-
ply and leave the washer door open to let air circulate
inside the tumbler.
[f the washer has been stored in
peratures, allow time for any water left over in the
washer to thaw out before use.
For information on
call Maytag Customer Service
U.S. customers using TTY for deaf, hearing impaired or speech impaired, call
CHECK THESE POmHTS mE YOUR MAYTAG NEPTUNE ® WASHER...
Freshening your. See Cleaning the Interior, page I I, washer
° Hake sure door is firmly closed.
The washer | will not | , | blake | sure | the | washer | is plugged in. |
|
|
|
| ||
start |
| o | blake | sure | the | water | source faucets | are | turned |
| on. |
| |
|
| o | blake | sure | to | press the Cycle | Selector | dial | to | start | the washen | ||
|
| o | Hake | sure | the | Control | Lock | is not | activated, | see | page | 6. | |
"Before the washer starts to fill, it will make a series of clicking noises to check the door lock and do a quick drain.
No | water | or insuffi- | Turn | both | faucets | on | fully. |
|
|
|
|
|
| ||
dent | water | supply | Hake | sure | the | door | is | tightly | closed, |
|
|
|
| ||
|
|
| Make | sure | the | washer |
| is plugged in. |
|
|
|
| |||
|
|
| Check fuse or reset circuit breaken |
|
|
|
| ||||||||
|
|
| Press | the | Cycle | Selector | dial | to | start | the washer. |
| ||||
|
|
| Straighten | water |
| inlet |
| hoses. |
|
|
|
|
|
| |
|
|
| Disconnect | hoses | and | clean | screens. | Hose | filter | screens | may be plugged. | ||||
|
|
| Open | and | close |
| the | door, then | press | the | Cycle | Selector | dial. | ||
Detergent remains in . blake sure the washer is running with sufficient water pressure.
the | automatic |
| dis- | See | Installation | Instructions. |
|
|
|
|
|
penser | after | the | wash | o Make | sure the | Detergent | Selector | is in the upper | position | when using granular | detergent. |
cycle is complete
Washer vibrates
is too noisy
or | . | blake | sure | the | washer | is | set | on | a | level | surface. | If the | surface | is not level, adjust the washer | |
|
| feet | to level | the | appliance. | See | Installation | Instructions. |
|
| |||||
| o | Make | sure | that | the shipping | bolts | are | removed. | See | Installation | Instructions. | ||||
| o | Make | sure | the | washer | is | not | touching | any | other | object. |
| |||
| o | Make | sure | the | laundry | load | is | balanced. |
|
|
|
|
| ||
CONT.
M2
