Maytag MAV-35 warranty Fills with the Wrong Temperature Water, Cycle Selector Advances Through Off

Fills with the Wrong Temperature Water

•Turn both faucets on fully.

•Make sure temperature selection is correct.

•If Auto Temperature Control is selected, cold water may feel warmer than cold water from the tap (see page 3).

•Make sure hoses are connected to correct faucets and inlet connections. Be sure water supply is regulated correctly. Flush water line before filling washer.

•Check the water heater. It should be set to deliver a minimum 120° F (49° C) hot water at the tap. Also check water heater capacity and recovery rate.

•Disconnect hoses and clean screens. Hose filter screens may be plugged.

Cycle Selector Advances Through Off

• Extra rinse is selected.

End of Cycle Chime Does Not Sound

•When Extended Spin (select models) is not selected, there may be a three-minute delay before chime sounds. This is normal.

•End of Cycle Chime switch (select models) is set to Lo or Off.

For further assistance contact Maytag ServicesSM, Maytag Customer Assistance:

U.S. 1-800-688-9900 or Canada 1-800-688-2002

U.S. customers using TTY for deaf, hearing impaired or speech impaired, call 1-800-688-2080.

NOTE: In our continuing effort to improve the quality of our appliances, it may be necessary to make changes to the appliance without revising this guide.

10