Maytag MDC4100 Convertible Dishwashers, Connecting a Convertible, Disconnecting a Convertible

Models: MDB4160 6 915555 B MDC4100 MDBD820 MDB4100 MDB3100

1 24
Download 24 pages 63.02 Kb
Page 9
Image 9
To Change the Door Panel Insert (select models)

To Change the Door Panel Insert (select models)

WARNING: Disconnect electrical power to the dishwasher before changing the door panel insert.

1.Using a Phillips screw driver, remove either the right or left-hand door trim strips by removing the three screws.

2.Grasp the panel insert(s) and gently flex out slightly. Slide Panel(s) out about two inches. Continue to flex insert panel(s) enough to remove them. Use care, edges may be

sharp.

3.Select color and reinstall panel(s). Place insert panel(s) (notched corners at the top) on the inside of the lower door panel trim. Make sure the upper notched corners of the insert(s) are under the control panel.

4.Reinstall the side trim.

 Convertible Dishwashers Convertible DishwashersConnecting a ConvertibleDisconnecting a Convertible

Connecting a Convertible

1Turn on the faucet at the sink until the water runs hot. Turn off the faucet.

2Pull the connector from the recess in the back of the dishwasher.

3Press down on the thumb release and lift the con- nector onto the faucet.

4Remove pressure from the thumb release and tug slightly on the connector to be sure it is securely in place.

5Turn the hot water on full force.

6Check that the sink drain is open so water from the dishwasher can drain properly.

7Pull the electrical cord from the recess. Plug it into a properly grounded outlet.

8Select the proper cycle and options for the load and start the dishwasher.

Note: To protect the laminate top from damage, do not use it as a cutting surface or resting place for warm/hot cookware. Do not slide ceramic or other hard or abrasive objects across the surface.

*Brand names are the trademarks of the respective manufacturer.

Disconnecting a Convertible

1Be sure to turn the water supply off and press the pres- sure release button BEFORE removing the con- nector.

2Press down on the thumb release and remove the connector from the faucet.

3Push the connector and hoses back into the cabinet recess.

4Unplug the electrical cord and push it back into the cabinet recess.

Care and Cleaning

Clean the cabinet and laminate top with a soft damp cloth and liquid spray cleaner.

To polish and protect the laminate top, use a product specifically developed for countertops such as Hope’s Countertop Polish*.

Apply an appliance wax to the cabinet once a year.

Thumb Release

Faucet

Connector

Pressure

Release

Button

8

Page 9
Image 9
Maytag MDC4100, MDB3100 Convertible Dishwashers, Connecting a Convertible, Disconnecting a Convertible, Care and Cleaning