Maytag MDB6600WH Problem Solution Odors, Noisy, Food Soils Remain, On Dishes, Did not Sanitize

PROBLEM	SOLUTION
ODORS	NOTE: If the dishwasher is not used daily, you can run a rinse cycle with the partial load until a full
	load is ready to run.
	Run a vinegar rinse through the dishwasher by putting 2 cups (500 mL) of white vinegar in an upright
	glass measuring cup in the lower rack. Run a normal cycle with the Heated Dry option turned off. Do
	not use detergent.
	The dishwasher may not be draining properly, see “WATER REMAINS IN THE TUB/WILL NOT
	DRAIN” in “Troubleshooting.”
NOISY	NOTES:
	■ Surging sounds can occur periodically throughout the cycle while the dishwasher is draining.
	■ Normal water valve hissing may be heard periodically.
	■ A normal snap sound may be heard when the detergent dispenser opens during the cycle and
	when the door is opened at the end of the cycle.
	■ Improper installation will affect noise levels.
	Be sure the filters are properly installed.
	A thumping sound may be heard if items extend beyond the racks and interfere with the wash arms.
	Readjust the dishware and resume the cycle.
FOOD SOILS REMAIN	Be sure the dishwasher is loaded correctly. Improper loading can greatly decrease the washing
ON DISHES	performance. See “Prepare and Load the Dishwasher”.
	Select the proper cycle and option for the type of soils. The Jetclean®/Jetclean® Plus Steam cycle
	with the Steam Sanitize option can be used for tougher loads.
	Be sure the incoming water temperature is at least 120°F (49ºC).
	Use the proper amount of fresh detergent. More detergent is needed for heavier-soiled loads and
	hard water conditions.
	Scrape food from dishes prior to loading (do not prerinse).
DID NOT SANITIZE	If the sanitized light is blinking, the load is NOT sanitized. The cycle was interrupted in the final rinse,
	or your water heater is set too low. Set your water heater to 120ºF (49ºC).
DAMAGE TO DISHWARE	Improper loading can cause dishes to become chipped or damaged. See specific loading
	instructions within this guide.
BLINKING LIGHTS	If the START/RESUME light is blinking, press START/RESUME and close the door within 3 seconds.
	If the Clean light or any other lights are blinking and the dishwasher will not run, call for service.

CLOUDY OR SPOTTED DISHWARE (AND HARD WATER SOLUTION)

NOTES:

■Liquid rinse aid is necessary for drying and to reduce spotting.

■Use the correct amount of detergent.

Confirm that the cloudiness is removable by soaking the item in white vinegar for 5 minutes. If the cloudiness disappears, it is due to hard water. Adjust the amount of detergent and rinse aid. See “HARD WATER (WHITE RESIDUE ON DISHWASHER INTERIOR OR GLASSWARE)” in “Troubleshooting.” If it does not come clear, it is due to etching (see below).

Be sure the incoming water temperature is set at 120°F (49ºC).

Try using the Hi Temp and Sani Rinse options.

To remove spotting, run a vinegar rinse through the dishwasher.

	■ Wash and rinse the affected dishware and load into dishwasher. Remove all silverware and metal
	items. Put 2 cups (500 mL) of white vinegar in a glass measuring cup in the lower rack. Run a
	normal cycle with the Heated Dry option turned off. No detergent is needed.
ETCHING (PERMANENT	This is an erosion of the surface of the glassware and can be caused by a combination of: water that
CLOUDINESS)	is too hot, from using too much detergent with soft water or by pre-washing. Detergent needs food
	soil to act upon. If etching has occurred, the glassware is permanently damaged. To avoid further
	etching, adjust the detergent amount to match the water hardness, stop pre-washing, and use water
	heating options only when incoming water temperature is below 120°F (49ºC).
LEAKING WATER	Be sure dishwasher has been installed properly and is level.
	Suds can cause the dishwasher to overflow. Measure the detergent accurately and use only
	detergents designed for use in a dishwasher. Less detergent is needed in soft water. Try another
	brand of detergent if sudsing continues.
	To avoid rinse aid leaking from the dispenser, be sure the lid is securely attached and avoid overfilling.
TUB IS DISCOLORED	NOTES:
	■ High iron content in the water can discolor the tub.
	■ Tomato-based foods can discolor the tub or dishware.
	A citrus-based cleaner can be used to clean.

11