Maytag MDB6600WH warranty Option Selections Options, Descriptions USE with Added Time to Cycle

OPTION SELECTIONS

OPTIONS	dish load types	DESCRIPTIONS	USE WITH:	ADDED
				TIME TO
				CYCLE
	Tough food soils	Adds heat and wash time to the	Jetclean® Plus Steam, Normal,	30 min.
		cycle.	and Auto Clean
	Tough food soils	Increases the target water	Jetclean® Plus Steam, Normal,	10 min.
		temperature during the wash portions	and Auto Clean
		of the cycle. Adds heat, time, and
		water.
	All loads	Use for best drying results in	Jetclean® Plus Steam, Normal,	45 min.
		combination with rinse aid. Turn off	Light, Quick Wash and Auto Clean
		when loads contain plastic
		dinnerware that may be sensitive to
		higher temperatures.
	To sanitize your dishes	Raises the water temperature in the	Jetclean® Plus Steam, Normal,	30 min.
	and glassware	final rinse to approximately 154°F	and Auto Clean
		(68°C). This high temperature rinse
		sanitizes your dishes and glassware
		in accordance with NSF/ANSI
		Standard 184 for Residential
		Dishwashers. Certified residential
		dishwashers are not intended for
		licensed food establishments. The
		Sanitize option adds heat and time to
		the cycle.
	All loads	Delays the start of a cycle up to	All cycles	120, 240,
		8 hours.		480 min.

	All loads	When Control Lock is lit, all buttons	All cycles
		are disabled. If you press any pad
		while your dishwasher is locked, the
		light flashes. The door can be opened
		while the controls are locked.
CONTROLS AND CYCLE STATUS
CONTROL	PURPOSE	COMMENTS
	To start or resume a	If the door is opened during a cycle or the power is interrupted, the START/RESUME
	wash cycle	indicator flashes. The cycle will not resume until the door is closed and START/RESUME is
		pressed.
		NOTE: If the START/RESUME button is located on top of door, push door firmly closed
		within 3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds,
		the start button LED will flash, an audible tone will be heard, and the cycle will not start.
	To reset any cycle or	Press CANCEL/DRAIN to reset any control selections made.
	options during
	selection.	See “Canceling A Cycle” and “Changing A Cycle After Dishwasher Is Started” sections.
	To cancel a wash
	cycle after it's
	started.
	To turn the audible	Press and hold the Hi Temp Wash button for 3 seconds to turn the audible tones on or off.
	tones on or off.	Only audible tones for confirming button presses can be turned on/off. Important audible
		tones, such as indicating a cycle has been interrupted, cannot be deactivated.
		NOTE: Audible tones are not available on all models.

6