Break off tag A on the cup fitted on the right side and tag B on the cup fitted on the left side. Then remove the paper from the self- adhesive surface under the plastic cups.
A
B
4. Fit the plastic cups so that the “tags” marked with arrows are against the front edge of the cover and side edge and press firmly onto the cover. Then break off the remaining tags.
5. Push the tumble dryer in under the metal angles, keeping the front edge raised 1 - 2 cm.
6. Lower the tumble dryer’s front feet into the plastic cups and adjust so that the dryer is balanced.
Air evacuation
Waste air from the tumble dryer must be conducted to an evacuation duct or to an outlet through the wall by means of the ac- companying vent hose.
Connection to the tumble dryer
The tumble dryer has three options for air evacuation: at the back, on the right side and on the left side. One hole is open when delivered. The other two have covers.
The tumble dryer comes with a connector (1), a plastic band (2) and a vent hose (3).
32 1
Fit the air evacuation system as follows: 1. Slip the vent hose onto the connector and secure using the plastic band.
2. Remove the plastic cover if you want to fit the vent hose to one of the holes other than the one already open.
3. Insert the connector with the vent hose into the opening.
4. Place the cover over the open hole.
Adjusting the feet
Screw the feet in or out so that the tumble dryer is steady and balanced on the floor or on the washing machine. Then tighten the locking nuts.
Locking nut
18
