Maytag MGC6536, MGC6430 B. Invert Cap In Appliance Pressure, Flame Appearance At Hi And Lo

B. INVERT CAP IN APPLIANCE PRESSURE

REGULATOR (See figure 11)

With the appliance installed, the appliance regulator should be located as shown in figure 3, 4 or 5.

CONVERSION OF APPLIANCE APPLYDOWNWARD

PRESSURE REGULATOR FINGERPRESSURE

ATDISCEDGESTO

REPLACEPININCAR

	CONVERTE_		LP
_lr,A	CAP	I	FINGERPRESSURE
			TOREMOVEPIN
	ND PIN	. J
			APPLYSIDEWARD
			FROMCAP

NAT I	.-"_		IL±
		I	I

After adjusting the screw the burner should produce a stable, steady blue flame of minimum size. The setting should be checked by turning knob from high to low several times without extinguishing the flame.

This operation will automatically provide the proper flame size at medium setting.

After Conversion Steps A, B and C have been completed, check the appearance of each burner flame at the Hi and Lo settings against figure 13. If the flames appear too large or too small, review each step to make sure it was completed correctly.

FLAME APPEARANCE AT HI AND LO

FIGURE 11

C. LOW FLAME ADJUSTMENT (See figure 12)

This appliance is shipped from the factory with low and high flame settings adjusted for use with natural gas. To set for use with LP proceed as follows:

1. Remove control knob from valve stem.

CAUTION: NEVER USE A METAL BLADE TO

PRY KNOB OFF: IF KNOB CANNOT BE EASILY

REMOVED, TUCK THE FOLDS OF A CLOTH

DISHTOWEL UNDER THE KNOB AND PULL THE

TOWEL UPWARD WITH STEADY; EVEN PRES_

SURE.

2.Carefully remove rubber grommet.

3.Locate the valve adjustment screw. See figure 12.

4.Insert a slender, thin-blade screwdriver into knob hole and engage blade with slot in adjusting screw.

5.Turn the adjusting screw clockwise until tight (5-7 in-lbs max.). Do not over tighten.

6.Replace rubber grommet and control knob.

7.Repeat for remaining burners.

FIGURE 13

KNOB

KNOB HOLE _

(KNOB AND GROMMENT REMOVED)

FIGURE12 ART_ 9215-209-0