Maytag MPE-33R WIRING DIAGRAM - 120 VOLT, WIRING - 120 VOLT, GROUND 120 V 1600 W, Wall Switch

WIRING DIAGRAM - 120 VOLT

Wiring diagrams are provided here for reference purposes only. This information is also provided on schematics attached directly to the appliance on the left side.

CAUTION: LABEL ALL WIRES PRIOR TO DISCONNECTION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DAN- GEROUS APPLIANCE OPERATION.

L1 = BLACK (POWER)

L2 = ORANGE (POWER) G = GREEN (GROUND) N = WHITE (COMMON) N1 = BLUE (COMMON) N2 = BLUE (COMMON)

Outside Switches
	Wall Switch	Wall Thermostat
	(power on/off)

Control Panel	Control Panel	Control Panel
	(power on/off)
Heater On/Off		Flame / Ember
Switch		On/Off Switch

	GROUND		N
			N2
			L2
MAIN POWER		N
			N1
HOME POWER		L
SUPPLY			L1
120 VAC

GROUND
	P-L
Light (L)	L-LIGHT
Flame Motor (L)	L-M
Fan Motor (L)	L-FAN
Heater 2 (L)	L-R2	Relay 1
Heater 1 (L)	Relay2
	R1-L
104° C 90°C

P SIP2

REMOTE

L-FLAME	N-FLAME	SIP6
K-P	K-
SIP4	H SIP3	TEM.

Circuit

Board

P-TRA.

N-M	N-FAN	POWER-N	N-LIGHT
		SIP13	SIP11
	SIP13		T-P	SIP7

Transformer

Figure 19

Temperature Sensor

Remote Sensor

WIRING - 120 VOLT

See Power Supply Specifications on Page 3.

HOME POWER -

SUPPLY 120 VAC

IF THE APPLIANCE IS TO BE HARD WIRED IN, THE POWER CORD MUST BE REMOVED (SEE INSTRUCTION #2 ON PAGE 5).

Figure 20

N		WHITE	N
		BLUE
			N1
		BLUE
			N2
L1	120 V AC	BLACK	L1	FIREPLACE WIRE
				HARNESS
		ORANGE	L2
G	YELLOW AND GREEN		GROUND

GROUND

120 V 1600 W

10

WARNING

Do not install or operate this fireplace through a switch wired in the 120 VAC or 240 VAC circuits. The only approved wiring for a switch is through the low voltage circuit (24 VAC) as shown on Page 14.

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.