Maytag MVWX550XW warranty Than normal, Installation. Drain hose extends into

TROUBLESHOOTING

First try the solutions suggested here or visit our website at www.maytag.com/help

for assistance and to possibly avoid a service call.

If you experience

Possible Causes

Solution

Washer not performing as expected (cont.)

Washer won’t run	Check proper electrical supply.	Plug power cord into a grounded 3 prong outlet.
or fill, washer stops
		Do not use an extension cord.
working (cont.)
		Ensure there is power to outlet.
		Reset a tripped circuit breaker. Replace any blown fuses.
		NOTE: If problems continue, contact an electrician.
	Normal washer operation.	Lid must be closed for washer to run.
		Washer will pause during certain phases of cycle. Do not
		interrupt cycle.
		Washer may be stopped to reduce suds.
		Washer spins the load before filling to determine load size.
	Washer not loaded as	Remove several items, rearrange load evenly in basket. Close
	recommended.	lid and press Start/Pause/Unlock.
		Do not add more than 1 or 2 additional items after cycle has
		started.
		Do not add more water to the washer.
	Not using HE detergent or using too	Only use HE detergent. Suds from regular detergents can slow
	much HE detergent.	or stop the washer. Always measure detergent and follow
		detergent directions based on your load requirements.
		To remove suds, cancel cycle. Select RInse & Spin. Press Start/
		Pause/Unlock. Do not add more detergent.
Washer not draining/	Empty pockets and use garment bags	Small items may have been caught in pump or between basket
spinning, loads are	for small items.	and tub, which can slow draining.
still wet	Use a cycle with a low spin speed.	Cycles with lower spin speeds remove less water than cycles
		with high spin speeds. Use the recommended cycle/speed spin
		for your garment. To remove extra water in the load, select Drain
		& Spin. Load may need to be rearranged to allow even
		distribution of the load in the basket.
	Washer not loaded properly.	Reduce load size to improve water removal. A tightly packed load
		may not allow the washer to spin correctly, leaving the load wetter
		than normal.
	Check plumbing for correct drain hose	Check drain hose for proper installation. Use drain hose form and
	installation. Drain hose extends into	securely attach to drainpipe or tub. Do not tape over drain opening.
	standpipe farther than 4.5" (114 mm).	Lower drain hose if the end is higher than 96" (2.4 m) above the floor.
		Remove any clogs from drain hose.
		11