Recessed Area and Closet Installation Instructions
This washer may be installed in a recessed area or closet.
Product Dimensions
H 
The installation spacing is in inches and is the minimum allowable. Additional spacing should be considered for ease of installation, servicing, and compliance with local codes and ordinances.
If closet door is installed, the minimum unobstructed air openings in the top and bottom are required. Louvered doors with equivalent air openings are acceptable.
|
| closet door |
| 48"2 | 14" |
| (310 cm2)* | (35.6 cm) |
|
| max. |
17" |
|
|
(43.2 cm) |
|
|
| 24"2 | 4" |
| (155 cm2)* | (10.2 cm) |
|
| min. |
0" | 0" | 1" (2.5 cm) |
(0 cm) | (0 cm) | min. |
Recessed front view | Closet side view |
D
A |
| G |
B
C
E
F
I
O
froid
chaud
K
J
H
P
M L
| 3" (7.6 cm) |
48"2 |
|
(310 cm2)* |
|
Front view | closet |
| door |
24"2 |
|
(155 cm2)* |
|
| 3" (7.6 cm) |
*Opening is the minimum for a closet door.
Louvered doors with equivalent air openings are acceptable.
■Additional spacing should be considered for the ease of installation and servicing.
■Additional clearances may be required for wall, door and floor moldings.
■Additional spacing of 1" (2.5 cm) on all sides of the washer is recommended to reduce noise transfer.
■Companion spacing should also be considered.
N
A. 43" (109 cm)
B. 38 | 1 | " (97 cm) |
⁄8 | ||
C. 35" (89 cm) | ||
D. 1¹⁄₂" (3.8 cm)
E. 27³⁄₄" (70.5 cm)
F. 25 | ¹⁄₂ | " (65 cm) |
| ||
G. Water inlets | ||
H. 7" (18 cm) | ||
I. Power supply cord
J. Drain hose connector
K.Label
L.27" (68.5 cm)
M.51⁄₄" (13.3 cm)
N.1" (2.5 cm)
O.Water level switch and shaft
P.5" (12.7 cm)
Drain System
Standpipe Drain System
The standpipe drain requires a minimum diameter standpipe of 2" (5 cm). The minimum
The top of the standpipe must be at least 39" (99 cm) high and no higher than 72" (183 cm) from the bottom of the washer.
4
