Maytag W10135283A Complete Installation, Additional Features, Level the washer

Models: W10135283A

1 20
Download 20 pages 896 b
Page 8
Image 8

Level the washer

1.Tilt washer forward raising back legs 1" (2.5 cm) off of floor. To adjust rear self-leveling legs, gently lower washer to floor.

2.Check levelness of the washer by placing a carpenter’s level on top of the washer, first side to side; then front to back.

3.If washer is not level, adjust the front legs up or down. Make final check with level.

4.When washer is level, use a wrench to turn the nuts on front legs up tightly against washer base. If nuts are not tight against washer base, the washer may vibrate.

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

6.Plug power supply cord into grounded 3 prong outlet.

NOTE: On some models, during factory testing, the timer is advanced partially into the cycle causing the start button to be depressed. Allow timer to advance to the end of the cycle. When the cycle is complete, the timer will reset and the start button will return to the start position. If the timer is not allowed to advance to the end of the first cycle and reset, the wash load will not be completed.

Complete Installation

1.Check the electrical requirements. Be sure that you have the correct electrical supply and the recommended grounding method.

2.Check to be sure all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.

3.Turn on water faucets and check for leaks. Tighten couplings if there is leaking. Do not overtighten; this could cause damage to faucets.

4.Check to be sure you have all of your tools.

5.Check that the shipping strap was removed from the back of the washer and used to secure the drain hose. If entire strap is not removed, washer may vibrate and be noisy.

Additional Features

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

To save water where applicable:

Locate water level switch on back of washer.

Turn shaft 45° counterclockwise.

8

Page 8
Image 8
Maytag W10135283A installation instructions Complete Installation, Additional Features, Level the washer