4.Close the door.
5.Press the POWER button.
6.Select a timed drying cycle and temperature (see following chart). Items containing foam, rubber or plastic must be dried on a clothesline or by using the Air Fluff temperature setting.
7.You must select a time by pressing TIMED CYCLE ADJUST Up or Down. Reset time as needed to complete drying. Refer to the following table.
8.Press (and hold) START button (about 1 second).
This chart shows examples of items that can be rack dried and the suggested cycle, temperature setting and drying time. Actual drying time will depend on the amount of moisture items hold.
Rack Dry | Setting | Temp. | Time* |
|
|
|
|
Wool Sweaters | Timed Dry | Low | 60 |
Block to shape and lay flat on the drying |
|
|
|
rack. |
|
|
|
|
|
|
|
Stuffed toys or pillows | Timed Dry | Low | 60 |
Cotton or polyester fiber filled |
|
|
|
|
|
|
|
Stuffed toys or pillows | Timed Dry | Air Fluff (no | 90 |
Foam rubber filled |
| heat) |
|
|
|
| |
|
|
|
|
Sneakers or canvas shoes | Timed Dry | Air Fluff (no | 90 |
|
| heat) |
|
|
|
|
|
*(Minutes) Reset time to complete drying, if needed.
DRYER CARE
Cleaning the Dryer Location
Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor for a garage installation.
Failure to do so can result in death, explosion, or fire.
Cleaning the Lint Screen
Clean the lint screen before each load. A screen blocked by lint can increase drying time.
IMPORTANT:
■Do not run the dryer with the lint screen loose, damaged, blocked or missing. Doing so can cause overheating and damage to both the dryer and fabrics.
■If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint.
Every load cleaning
1.The lint screen is located on the top of the dryer. Pull the lint screen toward you. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.
2.Push the lint screen firmly back into place.
28
