Maytag W10199659A Option Selections, Options, Dish Load Types, Descriptions, Use With, Comments

OPTION SELECTIONS

OPTIONS	DISH LOAD TYPES	DESCRIPTIONS	USE WITH:
	To sanitize your dishes and	Raises the water temperature in the final rinse to	Heavy Wash, Normal
	glassware in accordance	approximately 154°F (68°C). This high temperature rinse	Wash, Light, Insta
	with NSF/ANSI Standard	sanitizes your dishes and glassware in accordance with	Wash, or Auto Clean
	184 for Residential	NSF/ANSI Standard 184 for Residential Dishwashers.	Plus
	Dishwashers.	Certified residential dishwashers are not intended for
		licensed food establishments.
		The Sanitize option adds heat and time to the cycle.
	Use for loads with normal	Provides deep clean and shine by adding steam to the cycle.	Heavy, Normal, & Auto
	amounts of food soils;	Raises the water temperature in the final rinse to	Clean Plus cycles
	specialized option for
		approximately 154°F (68°C).
	stemware and glass
	cleaning.
	Loads containing tough,	Increases the target water temperature during the wash	Heavy, Normal, & Auto
	baked-on food.	portions of the cycle.	Clean Plus cycles
		Adds heat, wash time and water to the cycle.
	To run your dishwasher at	Delays the start of a cycle up to 6 hours.	All cycles
	a later time or during off-	Select a wash cycle and options. Press Delay. Press START/
	peak hours.
		RESUME. Close the door firmly.
Control Lock	To avoid unintended use of	To turn on Lock, press and hold Heated Dry for at least	Anytime
	your dishwasher, or cycle	3 seconds.
	and option changes during	To turn off Lock, press and hold Heated Dry for at least
	a cycle.
		3 seconds.
		When Control Lock is lit, all buttons are disabled. If you press
		any pad while your dishwasher is locked, the light flashes
		5 times. The dishwasher door can be opened while the
		controls are locked.

IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle will automatically compensate by adding time, heat and water as needed.

CONTROLS AND

CYCLE STATUS

CONTROL PURPOSE COMMENTS

To start or resume a wash cycle

If the door is opened during a cycle or the power is interrupted, all lights will flash to indicate a suspended cycle. The cycle will not resume until the door is closed and the START/RESUME button is pushed.

To cancel wash	Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let the dishwasher
cycle	drain completely.

To follow the progress and status of your dishwasher cycle

The “Clean” indicator glows when a cycle is finished.

If you select the Sanitize option, when the Sanitize cycle is finished, the Sanitized indicator glows. If your dishwasher did not properly sanitize your dishes, the light will not come on. This can happen if the cycle is interrupted, or the water could not be heated to the required temperature. The clean and sanitize lights go off when the door has been opened for more than 30 seconds or the CANCEL key is pressed.

The “Washing” indicator glows at the start of the first fill of any cycle (expect Rinse Only) and remains on until the end of the main wash cycle.

The “Drying” indicator glows during the drying portion of each cycle (expect Insta Wash and Rinse Only).

6