INSTALLATION REQUIREMENTS
TOOLS AND PARTS | Tools needed for gas installations: |
|
Gather the required tools and parts before starting installation.
Tools needed for all installations:
8" or 10" pipe wrench | 8" or 10" adjustable wrench |
| (for gas connections) |
#2 Phillips screwdriver |
|
|
|
| ||
|
|
|
| resistant to LP gas | |
|
|
|
| Parts supplied (all models): | |
Wire stripper (direct wire | Tin snips (new vent |
| |||
installations) | installations) |
|
|
| |
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
| Leveling legs (4) | ||
1/4" nut driver |
| Vent clamps | ||||||||
|
| Parts supplied (steam models): | ||||||||
(recommended) |
|
|
| |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Tape measure
Pliers |
“Y” connector
Long inlet hose
Short inlet hose
Rubber washer
Level |
| Caulking gun and compound | |
|
| (for installing new exhaust vent) | |
|
|
|
|
|
|
|
|
Adjustable wrench that | Utility knife |
opens to 1" (25 mm) or |
|
|
Parts package is located in dryer drum. Check that all parts are included.
NOTE: If installing dryer on pedestal, do not use leveling legs.
Check local codes. Check existing electrical supply and venting. See “Electrical Requirements” and “Venting Requirements” before purchasing parts.
Check code requirements. Some codes limit, or do not permit, installing dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.
Optional Equipment: (Not supplied with dryer)
Refer to your Use and Care Guide for information about accessories available for your dryer.
4
