Maytag W10289536A Style 2 Direct wire strain relief, Removable retaining nut Strain relief

Style 2: Direct wire strain relief

■Use Phillips screwdriver to remove screws and slide cord/conduit plate down and out.

■Position cord/conduit plate as shown in the following illustration.

■Replace cord/conduit plate and insert screws.

■Assemble a UL listed conduit connector in the opening.

A

B

A. Removable retaining nut

B. Strain relief

■Feed the flexible conduit through the strain relief, allowing enough slack to easily attach wiring to the terminal block.

■Tighten strain relief screw against the flexible conduit.

5.Replace back panel and screws on rear of range.

6.Complete installation following instructions for your type of electrical connection:

4-wire(recommended)

3-wire(if 4-wire is not available)

Electrical Connection Options

If your home has:	And you will be	Go to Section:
	connecting to:
4-wire receptacle	A UL listed,	4-wire connection:
(NEMA type 14-50R)	250-volt	Power supply cord
	minimum,
	40-amp, range
	power supply
	cord
4-wire direct	A fused	4-wire connection:
	disconnect or	Direct wire
5"	circuit breaker
	box
(12.7 cm)
3-wire receptacle	A UL listed,	3-wire connection:
(NEMA type 10-50R)	250-volt	Power supply cord
	minimum,
	40-amp, range
	power supply
	cord
3-wire direct	A fused	3-wire connection:
1"	disconnect or	Direct wire
(2.5 cm)	circuit breaker
	box
3"
(7.6 cm)

9