![](/images/new-backgrounds/1255581/25558125x1.webp)
2. Screw in leveling legs
2. Plan pipe fitting connection
diamond marking
A
B
A. 3/8" flexible gas connector B. 3/8" dryer pipe
D
C
C. 3/8" to 3/8" pipe elbow
D. 3/8"
Examine leveling legs, find diamond marking. Screw legs into leg holes by hand, use a wrench to finish turning legs until diamond marking is no longer visible.
Now stand the dryer on its feet. Slide the dryer until it is close to its final location. Leave enough room for electrical connection and to connect the exhaust vent.
MAKE GAS CONNECTION
1. Connect gas supply to dryer
Flared | |
B | |
male fitting | male fitting |
|
Remove red cap from gas pipe. Using a wrench to tighten, connect gas supply to dryer. Use
NOTE: For LP gas connections, you must use
†®TEFLON is a registered trademark of E.I. Dupont De Nemours and Company.
A combination of pipe fittings must be used to connect dryer to existing gas line. A recommended connection is shown. Your connection may be different, according to supply line type, size, and location.
3. Open shut-off valve
Closed valveA
BOpen valve
Open
Bubbles will show a leak. Correct any leaks found.
CONNECT INLET HOSES
For non-steam models, skip to “Connect Vent” on page 15.
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old hoses.
1. Turn cold water off, remove and replace rubber washer
Turn cold water faucet off and remove washer inlet hose.
Check and see if rubber washer is in the “Y” connector. Remove old rubber washer from inlet hose and replace with new rubber washer provided.
13