N.
REPLACING
NYLON
LINE
A
1)Loosen the locking nut on the base of the nylon head by turning it clockwise.
2)Remove the base cover assembly.
Remove the empty spool from the housing and discard any remaining line.
REWINDING NEW LINE
3)Prepare 2 lengths (8ft each) of 2.4 mm nylon line. Thread 1 end of each line into the two holes on opposite sides of the spool. Pinch the exposed ends flat with a pair of pliers to prevent them slipping through the hole.
4)Wind the two lines in the same direction around the spool.
REASSEMBLY
5)Slide the end of the two lines into the grooves to hold the line temporarily.
6)Position the spool back into the housing and pull the line through the eyelets.
7)Pull about 12cm (5ins) of line out on either side.
8)Reassemble the nylon string head as illustrated; mower gauge,spring and locking nut (tighten in an
9)N.B: In order to extend the nylon line as it wears down, pull the mower gauge downwards and turn it in a clockwise direction to feed out the desired length of line.
FAULT
FINDING
TABLE
| Engine will | Engine runs badly | The machine |
| not start | or looses power | runs but does |
| when cutting | not cut well | |
|
| ||
Check STOP switch is in the | • |
|
|
position I. |
|
| |
Control fuel level min. 25%tank | • | • |
|
capacity. |
| ||
Check air filter is clean. | • | • |
|
|
|
| |
|
|
|
|
Remove spark plug, dry it, clean it | • | • |
|
and adjust it, and replace it, if |
| ||
necessary. |
|
|
|
|
|
|
|
Change fuel filter. Contact your |
| • |
|
dealer. |
|
| |
Carefully follow the cutting |
|
| • |
accessory assembly instructions. |
|
| |
Check metal cutting accessory is |
|
| • |
sharp. Otherwise, contact your |
|
| |
dealer. |
|
|
|
|
|
|
|
Engine still gives trouble: contact your dealer.
11
