McCulloch 1600W, 96486380100 manual Preparation

2

3.Do not use the product if the electric cables are damaged or worn.

4.Immediately disconnect from the mains electricity sup- ply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical sup- ply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one.

5.Your electric cable must be uncoiled, coiled cables can overheat and reduce the efficiency of the product.

6.Do not pull cable around sharp objects.

7.Always switch off at the mains before disconnecting any plug, cable connector or extension cable.

8.Switch off, remove plug from mains and examine electric supply cable for damage or ageing before winding cable for storage. Do not repair a damaged cable, replace it with a new one. Use only genuine replacement cable.

9.Never carry the product by the cable.

10.Never pull on the cable to disconnect any of the plugs

11.Always wind cable carefully, avoiding kinking.

12.Use only on AC mains supply voltage shown on the product rating label.

13.Our products are double insulated to EN60335.

Under no circumstance should an earth be connect- ed to any part of the product.

Preparation

1.Always wear suitable clothing, gloves, and stout shoes.

2.The use of eye protection is recommended.

3.The use of ear protection is recommended.

4.To prevent dust irritation, the wearing of a face mask is recommended.

5.Do not wear loose clothing or jewellery that can be drawn into the air inlet.

6.Do not wear clothing with attachments, i.e. toggles or drawstrings that can be drawn into the air inlet.

7.Inspect your product before each use, especially the parts of the cutting head. Replace cutting line if worn or damaged.

8.Do not use if any part is damaged or broken or if any of the screws are loose. Have it repaired by an authorised repairer.

9. Always check your product is in a safe operating condition before use.

Use

1.Use the product only in daylight or good artificial light.

2.Do not use the product when it is raining or in damp and wet areas.

3.Never use the product in or near water or ponds.

4.Know how to stop the product quickly in an emer- gency.

5.On slopes, be extra careful of your footing and wear non-slip footwear.

6.Never pick up or carry the product by the cable.

7.Keep children, pets and bystanders at a safe dis- tance when using your product.

8.Keep long hair away from air inlet.

9.Keep all inlets clear of debris.

10.Always remain alert.

11.Do not attempt to use your product without the fully assembled debris bag fitted.

12.Never blow debris in the direction of bystanders.

13.Do not overreach. Keep proper footing and balance at all times.

14.The cutting head and cutting line continue to rotate after your product has been switched off.

15.Remove the plug from the mains :-

-before removing or replacing cutting line;

-before removing or replacing fully assembled debris bag;

-before leaving the product unattended for any period;

-before clearing a blockage;

-before checking, cleaning or working on the appli- ance;

-if the product starts to vibrate abnormally. Check

immediately. Excessive vibration can cause injury.

Maintenance and storage

1.Keep all nuts, bolts and screws tight to be sure the product is in a safe working condition.

2.Replace worn or damaged parts for safety.

3.After use the product should be stored in a safe place where it is protected from damage.

4.Inspect the collection bag regularly. If the collection bag becomes worn or damaged, replace.

CABLES		1.		No earth required. Our products are double insu-
IMPORTANT				lated to EN60335 and under no circumstances
•	Use only 1.00mm2 size cable up to 30 metres length			should an earth be connected to any part of the
	maximum.			product.
Maximum rating :		2.		Ensure the mains voltage suits your product
1.00mm2 size cable, 10 amps 250 volts AC.		3.		IMPORTANT!
•	THE GARDENVAC IS SUPPLIED WITH CABLE			The wires in the mains lead are coloured in accor-
	WIRED DIRECTLY INTO THE PRODUCT.			dance with the following code:
1.	Flymo Mains Cables and Extension Cables are			BLUE	-	NEUTRAL
	available from your local Electrolux Outdoor			BROWN	-	LIVE
	Products Approved Service Centre.			The wire which is coloured BLUE must be connect-
2.	Do not wire an extension cable directly to your prod-			ed to the Terminal which is marked with the letter 'N'
	uct yourself. Please contact your local Electrolux			or coloured BLACK.
	Outdoor Products Approved Service Centre for further			The wire which is coloured BROWN must be con-
	information on the connectors and kits available.			nected to the Terminal which is marked with the let-
3.	Only use extension cables specifically designed for			ter 'L' or coloured RED.
	outdoor use.	4.		It is important that the outer sheath is clamped cor-
CONNECTORS				rectly into the 3-pin plug.
IMPORTANT		5.		If in doubt consult your local Service Repairer or
•	Our connectors are suitable for use with 2 core cable			qualified electrician before the machine is used.
	only. Under no circumstances should these connec-	6.		A 13 Amp fuse must be fitted to the Mains Plug.
	tors be used for earthed products.	7.		The normal plug fuse and household fuse only pro-
•	All of our connectors and cables are of splashproof con-			tect the electrical equipment and are not a safe-
	struction. They are not waterproof and must not be left			guard against electrocution.
	outside permanently nor should they be submerged or
	immersed in water. Do not let cable lay or trail through
	pools of water or splashed with water from hose pipes.		If your product is hard wired i.e. non-detachable
			mains electric cable, a conversion kit and exten-
MAINS PLUG REPLACEMENT
IMPORTANT			sion cable is available from all Electrolux
•	If the plug supplied is cut off it should be		Outdoor Products Approved Service Centres
	destroyed. There is an electric shock hazard if a		which can be found in your local Yellow Pages.
	cut off plug is inserted into a 13 amp socket.