6
Caring for your Gardenvac
WARNING Never use water for cleaning your product, use only a dry cloth. Do not clean with chemicals or solvents, some can destroy critical plastic parts.
After Using Your Gardenvac (Q1, 2, 3 & 4)
1.Switch off and disconnect from the mains electricity sup- ply before cleaning your product.
2.Always empty the debris bag.
3.Take extra care to clean around the cutting head and the
collection chute.(Q1)
•Take care when cleaning around the cutting line area - sharp edges can cause injury.
4.Inspect the cutting line and replace if worn or damaged
5.Using a soft brush remove debris from all air inlets. (Q2)
6.Remove dirt and debris from debris fin.with a suitable tool. (Q3)
7.Wipe over your product with a soft dry cloth. (Q4)
Replacing the Cutting Line (Q5 & 6)
• Switch off and disconnect from the mains electricity supply before replacing the cutting line
• Handle the cutting line with care - sharp edges can cause injury.
1.Remove debris bag from product. See Page 4.
2.Remove cutting line (Q5) and discard safely.
3.If the cutting line becomes broken during use - use a suit- able tool to lever the line out of location. (Q6).
4.Place the cutting line into the slot in the cutting head. Ensure the cutting line is correctly located. See Page 3.
5.
Storing Your Gardenvac
Always store the product in a dry place ensuring the cable is not likely to be damaged on sharp edges etc.
Q1 | Q2 |
Q3 | Q4 |
Q5 | Q5 |
Fault Finding Hints
Fails To Operate
1.Is the power turned on?
2.Is the fully assembled debris bag correctly fitted to the product?
3.Check the fuse in the plug, if blown replace.
4.Fuse continues to blow?
Immediately disconnect from the mains electricity supply and consult your local Service Centre/Dealer/Distributor
Poor Blowing
1.The air inlets are blocked, clean all air inlets.
2.Mode indicator not in the right position?
3.If poor blowing persists?
Immediately disconnect from the mains electricity supply and consult your local Service Centre/Dealer/Distributor
Poor Vacuum/Jet Vacuum
1.The air inlets are blocked, clean all air inlets.
2.Mode indicator not in the right position?
3.If poor vacuuming persists?
Immediately disconnect from the mains electricity supply and consult your local Service Centre/Dealer/Distributor
Excessive Vibration
1.The cutting line is damaged - replace with new cutting line.
2.Ensure the fully assembled debris bag is correctly fitted to the product.
3.If excessive vibration persists?
Immediately disconnect from the mains electricity supply and consult your local Service Centre/Dealer/Distributor
Poor Shredding
1.The cutting line is damaged - replace with new cutting line.
2.TO PROLONG CUTTING LINE LIFE
The Gardenvac has been designed to shred leaves. If collecting large amounts of any other debris - remove the cutting line.
3.If poor shredding persists?
Immediately disconnect from the mains electricity supply and consult your local Service Centre/Dealer/Distributor
Service Recommendations
1.We strongly recommend that your product is serviced at least every twelve months, more often in a professional application.
2.Always use genuine Spare Parts.
3.Prepacked spares are available from most Electrolux Outdoor Products stockists.
4.Your product is uniquely identified by a silver and black product rating label
5.If you have a problem with your machine contact your local Approved Service Centre ensuring you have full details of your product as described on the product rating label.
6.Should it be necessary for work to be carried out by your Service Centre, it is important to take your complete
machine including cable and any extension cables used.
A network of specialist dealers can be found in your local Yellow Pages. To obtain service on your product simply telephone or visit your local Service Centre. Should you require service under the terms of our guarantee the Service Centre will require proof of purchase.
All of the centres listed stock genuine Spare Parts. NOTE: Our Service Repairers act on their own behalf and are not empowered to commit or legally bind Electrolux Outdoor Products in any manner whatsoever.
Environmental Information
Electrolux Outdoor Products are manufactured under an Environmental Management System (ISO 14001) using, where practical, components manufactured in the most environmentally responsible manner, according to company procedures, and with the potential for recycling at the end of the products’ life.
•Packaging is recyclable and plastic components have been labelled (where practical) for categorised recycling.
•Awareness of the environment must be considered when disposing of
•If necessary, contact your local authority for disposal information.
