3 |
|
| Assembly Instructions |
A | C |
B | D |
To Attach Debris Bag to Bag Frame
With bag frame on the ground:-
1.Fit first two holes on the plastic trim of the debris
bag to the first two location points on the front of the bag frame (where debris fin is attached). (A)
2.Fit next hole on the plastic trim to next location
point on bag frame. (B)
3. ...until all holes on the plastic trim of the debris bag are securely located to bag frame. (C)
•ENSURE THE DEBRIS BAG IS FITTED SECURELY TO THE BAG FRAME.
E | 1 |
| 4 |
| 3 |
| debris fin |
| 2 |
To Fit the Cutting Line to the Cutting Head (D)
•Switch off and disconnect from the mains electricity supply BEFORE removing or fitting the cutting line.
•Handle the cutting line with care - sharp edges can cause injury.
1. Place the cutting line into the slot in the cutting head and click into place as illustrated in Figure D.
•Ensure the cutting line is correctly located.
•ONLY USE CUTTING LINE SPECIFIED FOR THIS PROD-
UCT. SEE PRODUCT RATING LABEL FOR MODEL DETAILS
To Fit Assembled Debris Bag To Product (E)
•Switch off and disconnect from the mains electricity supply BEFORE REMOVING OR REPLACING the fully assembled debris bag.
•The cutting head and cutting line continue to rotate after your Gardenvac has been switched off.
IMPORTANT: Do not squeeze the trigger when fitting the debris bag (E1)
1.Ensure debris fin is horizontal (E2) as illustrated in fig E.
2.Locate bag frame into clip on the underside of product. (E3).
3.Lift handle towards product until bag latch locates and click into place. (E4)