McIntosh owner manual How to Operate the MA6300, con’t, How To Make A Tape Recording

How to Operate the MA6300, con’t

internal protection circuits will activate. The Front Panel Power Guard Indicators will continuously illuminate and the audio will be muted. When the MA6300 has returned to a safe operating temperature, normal operation will resume.

How To Make A Tape Recording

1. Select the signal you wish to record with the appropriate Source Push-button.

2. Adjust the record level using the recorder volume con- trol and proceed with the recording process.

3. To listen to the playback of the program source just recorded, press the TAPE Push-button.

Note: The MA6300 TAPE OUTPUTS are not affected by the

VOLUME or BALANCE controls.

Reset of Microprocessors

In the unlikely event the controls of the MA6300 stop functioning, the microprocessors can be reset by perform- ing the following:

1. Press and hold in the STANDBY/ON Push-button for approximately five seconds.

2. When the MA6300 cycles On then Off, release the STANDBY/ON Push-button.

3. When the STANDBY/ON LED is illuminated press the STANDBY/ON Push-button, the MA6300 will resume normal operation.

Note: This can be performed with the MA6300 On or in the Standby Mode.

Figure 9

Note: For an explanation of the Remote Control Push-button functions, refer to pages 16 and 17.

15