Specifications
Specifications
Power Output Per Channel | Power Requirements |
50 watts into 4 ohm load and 30 watts into 8 ohm load is | 100 Volts, 50/60Hz at 5.4 amps |
the minimum sine wave continuous average power output | 110 Volts, 50/60Hz at 4.9 amps |
per channel, all channels operating. | 120 Volts, 50/60Hz at 4.7 amps |
| 220 Volts, 50/60Hz at 3.1 amps |
Power Output Bridged | 230 Volts, 50/60Hz at 3.1 amps |
100 watts into 8 ohm load is the minimum sine wave con- | 240 Volts, 50/60Hz at 3.1 amps |
tinuous average power output per channel, all channels op- |
|
erating. | Note: Refer to the rear panel of the MC58 for the correct |
| voltage. |
Rated Power Band 20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power level from 250 milliwatts to rated power output is: 0.005% for 4 ohm loads
0.005% for 8 ohm loads
0.005% for Bridged Mode with 8 ohm loads
Dynamic Headroom 1.8dB
Frequency Response
+0,
Sensitivity
1 volt (2.5V at level control center detent position)
Wideband Damping Factor 100 @ 4 ohms
200 @ 8 ohms
Intermodulation Distortion
Maximum Intermodulation Distortion if instanta- neous peak output per channel does not exceed twice the rated output, for any combination of fre- quencies from 20Hz to 20,000Hz, with all channels operating is:
0.005% for 4 ohm loads
0.005% for 8 ohm loads
0.005% for Bridged Mode with 8 ohm loads
Input Impedance 20,000 ohms
Dimensions
Front Panel:
Weight
40 pounds (18.1Kg) net, 58 pounds (28.3Kg) in shipping carton
14