PMD-1024HLS User's Guide

Installing the PMD-1024HLS

When you connect the PMD-1024HLS for the first time, a Found New Hardware popup balloon (Windows XP) or dialog (other Windows versions) appear as the PMD-1024HLS is detected.

Another Found New Hardware balloon or dialog opens that identifies the PMD-1024HLS as a USB Human Interface Device.

When the balloon or dialog closes, the LED on the PMD-1024HLS should flash and then remain lit. This indicates that communication is established between the PMD-1024HLS and your computer

Caution! Do not disconnect any device from the USB bus while the computer is communicating with the PMD-1024HLS, or you may lose data and/or your ability to communicate with the PMD-1024HLS.

If the LED turns off

If the LED is lit but then turns off, the computer has lost communication with the PMD-1024HLS. To restore communication, disconnect the USB cable from the computer, and then reconnect it. This should restore communication, and the LED should turn back on.

2-3

Page 12
Image 12
Measurement Specialties PMD-1024HLS manual If the LED turns off