OPERATION
-Do not remove the plug from the socket by pulling the cable or the appliance itself.
-Do not run the appliance over the power cable.
-Do not use the appliance to vacuum lighted matches, cigarette ends or hot ashes.
-Do not use the appliance on wet surfaces.
-Do not obstruct the air intake or the air outlet vents.
-Do not use the appliance to vacuum needles, drawing pins or string.
ASSEMBLING THE VACUUM CLEANER:
Always remove the plug from the power socket before fitting or removing accessories.
ADJUSTMENT OF TELESCOPIC TUBE:
You can adjust the length of telescopic tube by pushing the button.
REMOVING THE HOSE:
Remove the plug from the power socket. To release the hose, press the buttons on the end of the hose and pull the hose firmly from the air intake duct.
INSTRUCTIONS FOR USE
Before using the appliance, unwind a sufficient length of cable and insert the plug into the power socket. A yellow mark on the power cable shows the ideal cable length. Do not extend the cable beyond the red mark.
To rewind the power cable, press the rewind button with one hand, and guide the cable with the other hand to ensure that it does not whip causing damage.
Press the ON/OFF button to switch the appliance on.
MOTORFILTER
The traditional dustbag has been replaced by a transparent dust container. When the dirt is inside this container it is rotating continuously to prevent the inlet from being covered with dust which enables the machine to maintain its suction power.
This means that while using this vacuum cleaner you will never have to purchase dustbags again!
IMPORTANT!
In order to maintain optimal suction power, remember to clean both the HEPA filter and the small motor filter each time you empty the dust container.
The vacuum cleaner is equipped with an overheat thermostat, which stops the vacuum cleaner if the motor is not properly ventilated. This may be the result of a blockage in the hose or the filters needing to be cleaned.
If the vacuum cleaner becomes unexpectedly blocked, you should unplug it and check the hose and filters. Then allow the vacuum cleaner to cool for approximately 20 minutes, after which time it will be ready for use again.
15
