Heavy Duty Power Equipment
Important Engine Information
DEK Engine Only—See Manufacturer’s manual for other engines
NOTE: The chipper/shredder operates most efficiently at the factory set engine speed of 3600 RPM. The speed is controlled by the governor, and the throttle setting should not be adjusted. Do not attempt to adjust the speed of the engine.
Emission Control System Information
The U.S. and California Clean Air Acts
EPA and California regulations require all manufacturers to furnish written instructions describing the operation and maintenance of emission control systems. The following instructions and procedures must be followed in order to keep the emissions from your DEK engine within the emission standards.
The emission control systems on your DEK engine were designed, built, and certified to conform with EPA and California emission regulations.
Maintenance, replacement, or repair of the emission control devices and systems may be performed by any engine repair provider, using parts that are ‘‘certified’’ to EPA standards. We recommend the use of genuine DEK parts whenever you have maintenance done. These
The use of aftermarket replacement parts, not of the original design and quality, may impair the effectiveness of your emission control system. A manufacturer of an aftermarket part assumes the responsibility that the part will not adversely affect emission control performance and must certify that use of the part will comply with emission regulations.
In the State of California a spark arrestor is required by law. Other states may have similar laws. Federal laws apply on all federal lands. If you equip the muffler with a spark arrestor, it must be maintained in effective working order.
Carbon Monoxide Gas
Exhaust contains poisonous carbon monoxide, a colorless and odorless gas. Breathing exhaust can cause loss of consciousness and may lead to death. To keep exhaust gas from accumulating, DO NOT use this product in a garage, basement, crawlspace, enclosed shed, or any other area without adequate ventilation. DO NOT use this equipment near ventilation ducts or open windows that may allow exhaust gasses to enter your home or business. ONLY operate this product outdoors.
The engine exhaust from this product and other components contain chemicals known to the State of California to cause cancer, birth defects or other reproductive harm.
Fire and Burn Hazards
The exhaust system gets hot enough to ignite some materials.
∙ Keep the power equipment at least 3 feet (1 meter) away from buildings and other equipment during operation.
∙ Do not enclose this product in any structure. ∙ Do not smoke when refueling.
∙ Keep flammable materials away.
∙ The muffler becomes very hot during operation and remains hot for a while after stopping the engine. Be careful not to touch the muffler while it is hot.
∙ Let the engine cool before storing.
∙ Refuel in a well ventilated area with the engine stopped.
∙ Fuel vapors are extremely flammable and may ignite after the engine has started. Make sure that any spilled fuel has been wiped up before starting the engine.
Rev: 07/2010 | Brush Master™ Chipper/Shredder with |
8