Heavy Duty Power Equipment
Your Responsibility
Safety Information
Restrict the use of this chipper/shredder to persons who read, understand and follow the warnings and instructions in this manual and on the machine.
Note: Not all safety labels shown may apply to your chipper/shredder.
Preparation
1.Thoroughly inspect the area where the chipper/ shredder is to be used. Remove all rocks, bottles, cans, or other foreign objects which could be picked up or thrown and cause personal injury or damage to the machine.
2.Avoid discharging chipped material out of the discharge chute against a wall or on asphalt, concrete, or other hard surfaces as material being ejected could ricochet, causing injury to you or bystanders.
3.Always wear safety glasses or safety goggles to protect eyes during operation or while performing an adjustment or repair.
4.Wear sturdy,
i.Never store machine or fuel container inside near an open flame, spark, or pilot light (e.g., furnace, water heater, space heater, clothes dryer, etc.).
j.To reduce the fire hazard, keep machine free of grass, leaves, or other debris
k.Allow machine to cool at least 5 minutes before storing.
8.Never attempt to make any adjustments while the engine (motor) is running (except where specifically recommended by the manufacturer).
Safety Label Locations
These labels warn you of potential hazards that can cause serious injury. Read them carefully. If a label comes off or becomes hard to read, contact your GXi Outdoor Power dealer for a replacement.
5.Before starting the engine, check bolts and screws for proper tightness to be sure the machine is in safe working condition. Also, visually inspect the chipper shredder at frequent intervals for any damage.
6.Maintain or replace safety and instructions labels, as necessary.
7.To avoid personal injury or property damage use extreme care in handling gasoline.
a.Use only an approved gasoline container.
b.Extinguish all cigarettes, cigars, pipes, and other sources of ignition.
c.Never fuel machine indoors.
d.Never remove gas cap or add fuel while the engine is hot or running.
e.Allow engine to cool at least two minutes before refueling.
f.Never over fill fuel tank. Leave at least 1/2 inch open below bottom of filler neck to provide space for fuel expansion.
g.Tighten gasoline cap securely.
h.If gasoline is spilled, wipe it off the engine and equipment. Move machine to another area and wait 5 minutes before starting the engine.
Safety Information
GXi Outdoor Power products are designed to give safe and dependable service if operated according to instructions. Read and understand this owner’s manual before operating your power equipment.
Operator Responsibility
Know how to stop your power equipment quickly in case of emergency. Understand the use of all controls and connections. Be sure that anyone who operates this power equipment receives proper instruction. Do not let children operate the power equipment without parental supervision.
Rev: 07/2010 | Brush Master™ Chipper/Shredder with |
5