Memorex MIHT5005 manual General Symptom, Possible Cause, Possible Solution

Check the following before requesting service:

GENERAL SYMPTOM	POSSIBLE CAUSE	POSSIBLE SOLUTION
No power.	AC cord unplugged.	Plug the AC cord into an AC outlet.
Power on, but unit not functioning	Condensation has formed.	Unplug the unit and wait about one to
properly.		two hours to allow the player to dry.
	Wrong type of CD inserted.	This unit cannotplay discs,other than
		shown on page 15.
	Unit needs to be reset.	Press the Standby/Power button, then
		unplug the power cord. Wait one minute
		and then plug the unit back in.
	The disc is dirty or inserted incorrectly.	Clean disc and insert label side-up.
	Some features and functions are not	This is normal; try another function.
	available on all discs.
No picture.	The equipment is not connected properly.	Connect the equipment according to
		the instructions in this manual.
	The INPUT of the TV is not set to receive	Select the appropriate video input
	the DVD signal output.	mode, usually VIDEO or AV.
	The video cables are not securely connected.	Connect the video cables securely.
	The connected TV power is off.	Turn the TV on.
No sound.	The equipment is not connected properly.	Connect the equipment according to
		the instructions in this manual.
	The external equipment connected to the	Connect as per this manual, and press
	AUX IN jacks is not connected properly.	the AUX Mode button on the remote.
	The speaker cables are not securely	Connect the speaker cables securely.
	connected.
	The external unit’s power is off.	Turn the external unit on.
Playback picture rolls.	Unit needs to be reset to NTSC.	Turn unit offand then back on to auto set it.
The playback picture is poor.	The disc is dirty.	Clean the disc.
The Search feature is not working.	Some discs have sections that do not	This is normal on some discs.
	allow searching.
The picture is not fitting properly.	Wrong menu option is selected in the	Select the correctTV type (PS, LB, WIDE)
	SETUP MENU.	which matchesthe TV you are using.
The remote control is not working.	The batteries are weak or dead.	Install fresh batteries.
	The batteries are not installed properly.	Install batteries according to the diagram.
	The remote is not aimed at the sensor.	Aim the remote at the sensor.
	Distance is too far or there is too much	Operate within 20ft or reduce the light
	light in the room.	in the room.
	There is an obstacle in the path of the	Move the obstacle.
	beam.

46