Memorex mph 6955 manual Installation, Charging the Battery Pack, Selecting a Location

Color profile: Disabled

Composite Default screen

Installation

Charging the Battery Pack

The rechargeable Nickel-Cadmium battery pack must be fully charged before using your phone for the first time. Before plugging the phone line into your new phone, you must charge the battery for approximately 15-20 hours without interruption.

1.Remove the handset battery cover. (For initial charging, the battery pack will already be inside the compartment, but will not be plugged in.)

2.Plug the battery’s cable into the handset.

The plastic connectors will fit together only one way. Make sure the battery’s connector is

NOTE properly aligned. Use only the battery pack (model BT-905) supplied with your phone.

3.Replace the battery cover.

▼Charging the Handset

Place the handset on the base to charge. (The handset can charge in either the face-up or face-down position.)

▼Low Battery Indicator

When the battery pack in the handset is low and needs to be charged, the BATT LOW LED flashes every 3 seconds.

If this occurs while you are on the phone, you will hear an alert tone. Complete your call as quickly as possible, and return the handset to the base for charging.

▼Cleaning the Battery Contacts

To maintain a good charge, it is important to clean all battery contacts on the handset and base about once a month. Use a pencil eraser or other contact cleaner.

Do not use any liquids or solvents.

Selecting a Location

Before choosing a location for your new phone, read the “Installation Considerations” included in the “Precautions and Important Safety Instructions” brochure.

!	Important: Do not place the power cord in an
	area where it may create a trip hazard or
	become chafed and create a fire or
	electrical hazard.

Setting the Dial Mode Switch

Place the switch in the

T position for tone dialing, or the P position for

pulse dialing.

5

H:...MPH 6955 Map OM.vp

Mon Jun 28 16:00:12 1999