Memorex MX3710 manual Listening to the Radio, TUNING/CD Skip

MX3710.O/M.QXD 4/30/02 10:49 AM Page 7

OPERATING INSTRUCTIONS (CONTINUED)

LISTENING TO THE RADIO

1

2

3

Press the POWER button to turn the unit on; the STANDBY indicator will go out.

Press the TUNER Function button

❶; “TUNER” will appear in the display. Press the BAND/ STOP(■) button❷ to select AM or FM.

Slide the FM MODE switch on the rear of the unit to the ST or MONO position to select Stereo or mono when listening to an FM station.

4				5
		2	1	1
				2
Press	the	TUNING/CD		SKIP/

SEARCH	❶ or	❷ button to	Adjust the PRESET EQ ❶ and
select a station (see Tuning note			VOLUME ❷ buttons as desired.
below).

NOTE: If the FM band is selected and you have tuned to an FM Stereo station, the FM Stereo indicator will light in the display.

6

When you have finished listening, press the POWER button to turn the unit off; the STANDBY indicator will light.

TUNING:

MANUAL TUNING: Repeatedly press the TUNING/CD SKIP/SEARCH or to manually advance the frequency in the display up or down until the desired frequency appears.

AUTOMATIC TUNING: Press and hold the TUNING/CD SKIP/SEARCH or until the frequency in the display starts to scan, and then release the button; the tuner will search and then stop on the next strong station it finds. Repeat this procedure until the desired frequency appears in the display.

Hints for Better Reception:

FM - Make sure that the FM Wire Antenna is extended to its full length. You may have to vary the direction of the antenna to find the strongest signal for each FM station.

AM - The AM ferrite bar antenna is located inside the unit. It may be necessary to turn the unit slightly so that the internal antenna is pointing in the direction of the AM transmitter. You may have to experiment to find the position that provides the strongest reception for each of your favorite AM stations.

7