Memorex URC-3550 manual Helpful Hints, Problem Solution

Trouble-Shooting

Helpful Hints

Problem:	Solution:
Red light does not blink	Replace batteries with 4 fresh,
when you press a key?	new AAA alkaline batteries.
The does not respond	Make sure you are using new
after pressing a key?	batteries and are aiming the at
	your device.
The does not operate	A) Try all the codes listed for
your device(s)?	your brand. B) Try the search
	method on page 15.
Your brand is not listed	Try the search method on page
in the code section?	15.
When following the	Did you use the Code Lock
set-up instructions, the	feature? You must first unlock
red light on the only	the code before entering a new
blinks once instead of	code. Follow the instructions
twice after you enter a	on page 14 to do this.
three-digit code?
The is not preforming	You may be using the wrong
commands properly?	code. Start the search method
	over again to locate the proper
	code.
Press a key but get the	Hold SETUP until the red light
wrong result?	blinks twice, then press 992
	and the device key twice. You
	will need to set-up your device
	again. Try the codes for brand
	or the search method on page 15.
You cannot control	Hold SETUP until red light
the volume feature of	blinks twice. Then press 993
your Satellite, Cable	and VOL+. To set the volume
Converter or TV/ Video	control back to TV (Punch
combination OR you	Through), hold SETUP until
cannot control the	the red light blinks twice, then
volume of the TV set up	press 993 TV.
on the AUX key?
Problems changing	Enter the programme number
channels?	exactly as you would on your
	original remote.
Video not recording?	As a safety feature on your you
	must press the Record key twice.

17