Unpacking your speakers
Before you begin installation you should ensure that your DSP loudspeakers are the correct voltage for your local AC supply. If they are not, do not try to install them, and contact your dealer.
You should not make any connections to the DSP loudspeakers, or to any other component in your system, while the AC power supply is connected and switched on.
Components
Each DSP loudspeaker system is supplied with the following components:
•One power cord per speaker.
•Meridian M5 lead (8m).
•Meridian S5 lead (8m).
If any of these items is missing please contact your dealer. We suggest that you retain the packaging carefully for maximum protection in transit.
Removing the grilles
DSP3100: The grille is held tightly in place by the side metal plates. Gently pull it from the top edge, taking care not to scratch the
DSP3100HC: The grille is held on by pegs. Gently pull from the sides and then top and bottom to remove it.
Note: The speakers are designed to be used with their grilles fitted.
Master and slave |
|
|
When two 3100 loudspeakers are supplied as a |
|
|
pair, one speaker is preconfigured as Left Master |
|
|
and the other as Right Slave. This allows you to |
|
|
set up a | Left Master | Right Slave |
configuration: |
|
|
Cleaning the speakers
Greasy marks should be removed from the metal surfaces by light rubbing with a slightly damp cloth and a trace of proprietary glass cleaner. Do not use any other solvent or abrasive based cleaners.
On black speakers, small marks on the lacquer surface can usually be removed by treating with Black Turtle Wax Color Magic. Do not use any coarse polish such as Auto Colour restorer, and always test any polish on a