Alternatively you can configure the speaker as a slave, with the D2 input used for all sources, as follows:
• Press the green > (Play) key on the remote |
|
| |
L. | Slv2 | ||
repeatedly until the display shows: | |||
|
| ||
|
|
When you have configured the loudspeaker:
•Switch off the 3100 loudspeaker, using the power switch on the back, and then switch on again to restore normal operation.
Custom configuration
This mode allows you to check or alter the individual settings defined by the standard Type settings.
•Turn off the DSP loudspeaker, using the power switch on the back panel.
•Turn on the power again while holding down the 0 key on the remote.
The display will show the current setting of the first configuration option.
•Press > or < to step between the options.
•Press A or V to change the value of the current option.
The table below shows the options you can configure:
Option | Initial value in Type 1 | |
Position and master/slave | L. |
|
Compatibility (G, 500, 200 Pre, or 200 CD)* | G. |
|
Controller mode (Auto, Con, or NCon) | Auto. | |
System address | S.A. | 1 |
Diagnostic displays? (N or Y) | Diag. | N |
Product address | P.A. | 1 |
Volume mode (1=normal, 2/3=second/additional | L.E. | 1 |
room) |
|
|
Balance control? (N or Y) | Bal. | Y |
Centre menus? (N or Y) | Centre menus? (N or Y) | |
*G gives 500 Comms and MSR+ sources, 500 gives 500 Comms and MSR sources, and 200 Pre or 200 CD are legacy modes.
