Meridian America Meridian DSP manual Configuring the sources, RD Radio, To configure a source

CONFIGURING THE

DSP LOUDSPEAKERS

Configuring the sources

When the master DSP loudspeaker is set to one of the standard Types the 12 source selection keys on the remote select inputs D1 and D2 as shown in the table on page 34.

If the configuration you want is not catered for by one of the standard settings, you can configure each source individually.

The DSP loudspeakers provide 12 sources corresponding to the 12 source selection keys on the remote:

CD, Radio, LP, TV, Tape1, Tape2, CDR, Cable, DVD, VCR1, VCR2, and

LD.

For each source you can configure:

¥The label used for it on the front panel display, from a range of alternative labels.

¥The digital input it selects.

¥The comms type and address, to control other Meridian 500 Series equipment.

¥Other advanced options.

You only need to configure the sources on the DSP loudspeaker you have specified as the master.

To configure a source

While in configuration mode:

¥Press the source key on the remote corresponding to the source you want to configure.

For example, to configure the Radio	RD Radio
source the display initially shows:
¥ Press > or < to step between options.

The right-hand set of characters shows the current value of the option.

¥Press A or V to change the value of the option.

When you have finished programming sources:

¥Switch off at the back panel, and then switch on again to restore normal operation.

33