Meridian America Meridian DSP manual Configuring the setup options, Free, To select Setup mode

CONFIGURING THE

DSP LOUDSPEAKERS

Configuring the setup options

When configuring the DSP

loudspeakers, point the remote at the speakers, even if you have a Meridian Surround Controller.

The setup options allow you to adjust the frequency response of the loudspeakers to compensate for their position. You only need to configure the master loudspeaker.

To select Setup mode

¥Turn off the DSP loudspeaker using the power switch on the back panel.

¥Turn on the power again while holding down the Store key on the remote.

The display will show:	Setup
It will then revert to standby:	.

You can now operate the speaker in the usual way, using the additional setup menus to adjust the response while listening to sources.

When you have finished adjusting the setup options:

¥Switch off at the back panel, and then switch on again to restore normal operation with the setup you have programmed.

To adjust the frequency response

¥Press Function > or Function < until the display shows the current response setting.

For example: Free

¥Press Function A or Function V to select the appropriate option as follows:

Option

Free

Boundary

Sub.1

Sub.2

Corner

What it means

Flat frequency response

Speaker closer than 0.5m (20") to a wall.

Applies a second-order high-pass filter at 80Hz for use with an analogue subwoofer.

Applies a second-order high-pass filter at 120Hz for use with an analogue subwoofer.

Speaker closer than 0.5m (20") to a corner.

35