INSTALLING THE
CD PLAYER
The following automatic setup procedure should be used to set up the
Comms correctly between several products:
•Connect one of the DIN COMMS sockets on the back panel of the CD player to one of the COMMS sockets on another G Series, 500 Series, or 800 Series unit, using the Comms leads provided with the products.
The sequence in which you connect the units is not important.
•Switch all the units to standby.
•Press Clear (remote).
Each unit will display:
One unit will then be designated as the controller, and display:
All the other units will be configured as
Auto
Controller
Not Con.
If for any reason the automatic setup does not work, make sure you are operating the remote from a position where all the units can receive the
If this fails:
•Restore the default operation by selecting one of the standard types; see Choosing a standard setting, page 30.
Do not, under
any circumstances, connect any
equipment other than Meridian G Series, 500 Series, or 800 Series to any socket marked COMMS on the back of the product.
27