CONFIGURING THE
CD PLAYER
Choosing a standard setting
The CD player provides several sets of standard settings, called Types, which configure all aspects of the 808 into one of a number of alternative standard configurations.
Types 0 to 3 are factory settings, designed to cater for the most commonly needed configurations of associated equipment.
These standard Types are shown in the following table:
Type Description
0CD player, variable output, all sources internal.
1CD Player, fixed output, all sources internal.
2Preamplifier, fixed output, CD internal, all other sources external (808i only).
3Preamplifier as above but variable output (808i only).
In addition, your installer may have provided one or more named User Types, with settings appropriate to the configuration of equipment when your 808 was installed.
You can reset the configuration of the CD player to any of these Types to restore it to the state it was in when it was installed. Note: Selecting a Type will clear any configuration changes you have made.
To select a standard setting
Warning: this procedure will reset any configuration changes you have made.
•Switch off any power amplifiers that are connected to the 808 and put any digital speakers into standby.
•Put the CD player into standby by pressing Off (front panel or remote).
•Press and hold down Volume A (under the front panel).
The display shows: | Type in... | 3 |
• Keep holding down Volume A for a further three seconds.
The display shows:
Then after a short delay the display shows the current Type.
For example:
Type 1
30
