Metra Electronics 95-7801 installation instructions Honda Prelude, Fig. C

95-7801 DASH DISASSEMBLY

HONDA PRELUDE 1992-1996

1Disconnect the negative battery terminal to prevent an accidental short circuit.

2Remove (2) screws from the top of the con- sole trim bezel. Slide the front seats back and remove (4) Phillips screws from each side of the bezel. Pull up on the console trim bezel and remove. Using an angled screwdriver, remove (2) screws securing the gear shifter bracket to the bezel. Remove (4) screws from the radio trim bezel, remove the factory head unit assem- bly and disconnect the wiring. (Fig. A)

3Cut and remove the mounting tabs from the bottom of the Rear Support Tray (Fig. B). Cut and remove all mounting clips on the Radio Housing EXCEPT clips “F” and "H" (Fig. B). Cut and remove the slots on the bottom of the ISO Brackets (Fig. C).

Skip to step #3b on Page 10.

A

B2

Fig. B

"F"
"H"	Fig. C
"F"
"H"

HONDA PRELUDE 1997-2001

1Disconnect the negative battery terminal to prevent an accidental short circuit.

2Using a panel removal tool, unclip the radio trim bezel and remove (some force may be required). Remove (4) Phillips screws securing the factory head unit/bracket housing assembly and disconnect the wiring. Remove (4) Phillips screws secur- ing the factory head unit to the bracket housing and remove. (Fig. A)

3Cut and remove all mounting clips on the Radio Housing EXCEPT clips "A" and "G". (Fig. B) Skip to step #3a on Page 9.

A

B"A"

"A"

"G"

"G"

8