Metra Electronics 95-7801 installation instructions Honda Accord, Fig. B Skip to step #3b on

95-7801 DASH DISASSEMBLY

HONDA ACCORD 1990-1993

1Disconnect the negative battery terminal to prevent an accidental short circuit.

2Remove (4) screws from the lower portion of the center console. Remove the gear shifter knob and lift the console out. Remove the ashtray and ashtray bracket. Remove (2) screws from the bottom of the head unit support, slide the unit out and disconnect the wiring. (Fig. A)

3Cut and remove all mounting clips on the Radio Housing EXCEPT clips "C" and "H" (Fig. A). Cut and remove the slots on the bottom of the ISO Brackets (Fig. B). (THE

REAR SUPPORT TRAY WILL NOT BE USED).

(Fig. B) Skip to step #3b on Page 10.

A

B

"C"

Fig. A

"C"

	"H"
Fig. B	"H"

HONDA ACCORD 1994-1997

1Disconnect the negative battery terminal to prevent an accidental short circuit.

2Remove the ashtray and (1) 3/4" #8 Phillips screw exposed. Open the storage compart- ment and remove (2) #8 Phillips screws exposed. Remove the cupholder tray and

(3) #8 Phillips screws inside. Lift the cen- ter console out and remove (2) Phillips screws exposed at the base of the dash trim bezel. Unclip the bezel and remove. Remove (2) hex-head screws securing the factory head unit and disconnect the wiring. (Fig. A)

3Cut and remove all mounting clips on the Radio Housing EXCEPT clips "A" and "H". (Fig. B) Skip to step #3b on Page 10.

A

B"A"

"A"

"H"

"H"

4