Metra Electronics 95-7801 installation instructions Honda CRV, Fig. a

95-7801 DASH DISASSEMBLY

HONDA CRV 1997-2001

1Disconnect the negative battery terminal to pre- vent an accidental short circuit.

2Open the glove box, squeeze the retaining clips and remove the stoppers. Lower the glove box and remove (2) Phillips screws from the left edge. Remove (2) Phillips screws from the lower steering column panel and remove. Unclip the lower console cover (below the ashtray and pocket) and remove. Remove (2) Phillips screws from the base of the center console, open the console pocket and remove the (4) outer screws exposed. Unclip the center console and remove. Remove (2) Phillips screws securing the radio trim bezel, disconnect the wiring, and remove the trim bezel/head unit assembly. Remove (4) Phillips screws securing the head unit to the bezel and remove. (Fig. A)

3Cut and remove all mounting clips on the Radio Housing EXCEPT clips "B" and "H" (Fig. A). Cut and remove the slots on the bottom of the ISO Brackets (Fig. B). Skip to step #3a on Page 9.

A

B		"B"
	Fig. A	"B"
		"H"
		"H"

Fig. B

HONDA CRV 2002-2006

1Disconnect the negative battery terminal to pre- vent an accidental short circuit.

2Remove (2) Phillips from the bottom edge of the radio trim bezel. Unclip the trim bezel and remove. Remove (4) Phillips screws securing the factory head unit and disconnect the wiring.

(Fig. A)

3Cut and remove all mounting clips on the Radio Housing EXCEPT clips "C" and "H". (Fig. B) Skip to step #3a on Page 9.

A

B"C"

"C"

"H"

"H"

6