4
rqposn
INSTALLING THE IS6520-41/MS6520-41 TO THE HOST SYSTEM
1. Turn off the host system.
2. Connect the 10-pin RJ45 male connector into the jack on the Cubit®
IS6520/MS6520. You will hear a ‘click’ when the connection is made.
Note: If the Cubit IS6520 is receiving power from the host system, skip to
step #5. (See caution statement below)
3. Connect the L-shaped plug of the power supply into the power jack on the
PowerLink cable.
4. Connect the power supply into an AC outlet. Make sure the AC input
requirements of the power supply match the AC outlet.
5. Connect the PowerLink cable to the proper port on the host system.
6. Turn on the host system.
Note: Plugging the scanner into a port on the host system does not guarantee
that scanned information will be communicated properly to the host
system. The scanner is shipped from the factory programmed with
default settings. Please refer to the MetroSelect® Programming Manual
(MLPN 2407) for instructions on changing the scanner’s configuration. In
addition, please check that the scanner and host system are using the
same communication protocol.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner
must meet the requirements for SELV (Safety Extra Low Voltage) according to
EN 60950.
To maintain compliance with standard CSA C22.2 No. 950/UL 1950 and norm EN 60950,
the power source should meet applicable performance requirements for a limited power
source.