Metrologic Instruments IS6520 - page 9

3

QUICK START

1. Connect the 10-pin RJ45 male connector into the jack on the Cubit®

IS6520/MS6520. You will hear a ‘click’ when the connection is made.

2. Connect the L-shaped plug of the power supply into the power jack on the

PowerLink cable.

3. Connect the power supply into an AC outlet. Make sure the AC input

requirements of the power supply match the AC outlet.

4. When the IS6520 is ready to scan, the green LED will turn on, the red LED

will flash and the scanner will beep once.

5. Place a bar code in front of the scanning window. The scanner will beep

once and flash the red LED if the bar code was successfully decoded.

NOTE: Cubit® is shipped from the factory programmed with default

settings. Refer to the MetroSelect® Programming Guide for

instructions on how to configure the scanner.

p

no

q

r

Contents

Main Page ii L Corporate Headquarters Copyright Page T ABLE OF C Page I S CANNER AND A Page r q p o n s I NSTALLING THE IS6520-41/MS6520-41 TO THE H OST S r q p o & t sn u Page S CANNER P A. C B B. S AUDIBLE INDICATORS FAILURE MODES VISUAL INDICATORS PROGRAMMING MODES Page PROGRAMMING MODES (CONTINUED) Page 16 OPTIMAL LOW AND CLOSE DEPTH OF FIELD 17 OPTIMAL HIGH AND NORMAL DEPTH OF FIELD F AR D EPTH OF F TROUBLESHOOTING GUIDE IS6520/MS6520 Series Troubleshooting Guide Page Page Page APPENDIX A Design Specifications Operational Mechanical APPENDIX A (CONTINUED) Design Specifications Electrical Environmental APPENDIX B Default Settings * Page Page APPENDIX C Scanner Pinout Connections Cable Connector Configurations APPENDIX C (CONTINUED) Keyboard Wedge Powerlink and Adapter Cable (MLPN 54-54008) PowerLink Cable Adapter Cable 5-pin Female DIN 5-pin Male DIN 6-pin Male Mini-DIN 6-pin Female Mini-DIN APPENDIX D Warranty and Disclaimer Limited Warranty APPENDIX E Notices Notice Remarque Caution APPENDIX E (CONTINUED) European Standard Funkstreigenschaften nach EN 55022:1998 Standard Europeo APPENDIX F Patents Page I O P Q R S