Metrologic Instruments MLPN 2159 manual Back Plate Installation

Back Plate Installation
With the Metrologic back plate
(Part #45473), position the scanner
in one of two directions. The two
orientation choices are vertical or
horizontal. (Refer to Figure 4). To
use this stand, use the four 6-32 x ½
inch machine screws and four wood
screws to attach the unit to the back
plate and work surface. The maxi-
mum distance the screws should go	Figure 4
into the scanner is a ½ inch.

1.Drill four holes into the work surface that correspond with the holes indicated by an XY in Figure 5.

2.To fasten the scanner to the back plate:

!For a horizontal mount, align the four holes on the back of the scanner with the four clearance holes located on the back plate marked with an X in Figure 5.

!For a vertical mount, align the four holes on the back of the scanner with the four clearance holes located on the back plate marked with a Y in Figure 5.

3.Fasten the scanner to the back plate by inserting the four 6-32 x ½ inch screws into the four holes in the scanner’s case. Fasten the scanner and back plate to the work surface.

Figure 5

5