Stand Installation
With the Metrologic stand (Part #45475), the scanner can be positioned in one of two directions. The two orientation choices are vertical or horizontal. (Refer to Figure 1)
To install this stand, use the four 6- |
|
32 x ½ inch machine screws and two |
|
#10 panhead wood screws. | Figure 1 |
1.Drill two holes into the work surface that are the same size and distance as the holes on the stand base. (Refer to Figure 2)
2.Use the two #10 panhead wood screws to attach the stand to the work surface.
3.To fasten the scanner:
!For a horizontal mount, align the four holes on the back of the scanner with the four clearance holes located on the stand marked with an X in Figure 3.
!For a vertical mount, align the four holes on the back of the scanner with the four clearance holes located on the stand marked with a Y in Figure 3.
Base of Stand |
Figure 2
Figure 3
4.Fasten the scanner to the stand by inserting the four
4
